Epomarine EX-300

PRODUCT DESCRIPTION

& INTENDED USES

產品簡介

FEATURES

產品特性

EPOMARINE EX-300

環氧涂料

A high-build modified epomarine epoxy coating with polyamide

hardener

聚酰胺固化的厚涂型改性環氧漆。

z Obtainable thicker coating

適用厚涂

z Tough and hard, and very good abrasion

resistance

漆膜堅韌,耐磨損性能很好

z Quick drying

干燥快

z Good adhesion to zinc primer

同富鋅底漆附著力很好

BASIC DATA

基本數據

Color(s)

顏色

Mixing ratio

混合比率

Solids content

重量固體份

Film thickness

涂裝膜厚

Spreading rate

涂覆率

White and colors

各色

Base/Hardener=90/10 (by wt.)

主劑/固化劑=90/10（重量比）

69%

Dry : 120 microns/coat Wet : 190microns/coat

干膜: 120mm/道 濕膜: 190mm/道

Theoretical: 0.333kg/m 2/120 microns

理論值 : 0.333 千克/平方米/120mm

Practical: Various depending on surface conditions, environment,

applications, etc.

實際值 : 與表面處理, 外界環境, 施工方法等多種因素有關。

STORAGE

儲存

Shelf temperature

儲存溫度

Shelf life

儲存期限

Flash point

閃點

0℃-40℃

1 year

1 年

Greater than

8

8 以上

APPLICATION DATA

施工數據

Pot life

混合使用期

Temperature (℃)溫度

Pot life (hrs) 混合

使用期

Airless spray, air spray, brush and

roller

無氣噴涂、空氣噴涂、刷涂及輥涂

Airless

spray

Nozzle

tip

Fluid

pressure

Thinning

Thinner
稀釋劑

Application temperature
施工溫度

Drying time &
Overcoating interval
干燥時間&涂裝間隔

Epomarine Thinner 20

環氧稀釋劑 20

5℃-40℃

Temperature (℃)

Dry to touch (hrs)

Dry hard (hrs)

Min. interval (hrs)

Max. interval (days)

PAINTING SYSTEM
涂裝配套

Applied substrates
適用底材

Preceding coat
適用下涂

Subsequent coat
適用上涂

Bare steel, shop primed surface.

裸鋼、車間底漆表面。

SD Zinc 500.

Epomarine EX 500、Epomarine EX 600、Epomarine Super EX 21,

or according to the coating systems of Kansai.

Eomarine EX 500、Epomarine EX 600、Epomarine super EX21AC, 或

參考我司推薦配套

If there is any doubt, please consult Tianjin Kansai Paint for

standard

painting system.

如有任何疑問，請向天津關西查詢標準配套。

SURFACE PREPARATION
表面處理

z Remove salt and other water-soluble contaminants by fresh water
hosing.

用清水沖去鹽份及其它水溶性污物。

z Degrease according to SSPC-SP1 solvent cleaning.
依照 SSPC-SP1 溶劑清洗標準除去油脂。

z Remove weld spatter and smooth weld seams and sharp edges.
除去焊接飛濺并處理焊縫、毛刺使其光順。

z Remove rust, mill-scale and damaged shop primer by blasting to
ISO Sa2.5 (SSPC-SP10) or by power tooling to ISO St3.

用噴砂方式除去鐵銹、氧化皮和損壞的車間底漆達到 ISO Sa2.5

(SSPC-SP10) 或用電動工具處理表面達到 ISO St3。

z Remove dust and dirt by high-pressure air before paint application

用高壓空氣吹掃除去灰塵等污物。

z Be sure that the surface is clean and dry prior to application.

施工前確認表面清潔干燥。

SAFETY PRECAUTIONS

安全措施

A health and safety data sheet for product is available upon request.

Minimum precautions to be taken in dealing with all paints are:

任何油漆施工中均應保證提供以下措施:

z Avoid skin and eye contact.

避免接觸皮膚和眼睛。

z If paint comes into contact with the skin , wash with warm water

and/or a suitable cleanser. If paint comes into contact with the eyes,

flush with copious amount of water and seek immediate medical

attention.

如果油漆接觸到皮膚，應用溫水以及（或者）適當的清洗劑清

洗。如果油漆接觸到眼睛，應用大量水沖洗并立即就醫。

z Ensure good ventilation.

保證良好的通風。

z Paint products contain flammable materials. Please keep them away

from sparks and prohibit any smoking in the vicinity.

涂料中含有可燃物質。請遠離火花并禁止在臨近地區吸煙。

z Observe all health and safety data on the container.

現場遵守一切健康安全規定。

DISCLAIMER

提請注意

The information given on this sheet is to the best of our knowledge and

accurate at the time of printing. Since conditions of use are beyond the

manufacture's control, information contained herein is without

warranty, implied or otherwise, and the suitability of the material for

the use contemplated is the sole responsibility of the buyer. The

information contained on this data sheet is subject to modification at

any time due to our policy of modification and product development.

EPOMARINE EX-300

本說明書所提供信息均為目前我方所掌握最全面正確的資料,鑒于

產品使用條件非我方所能控制，此中信息不含擔保，即僅在選取產

品上對買方負責。由于我公司產品及生產工藝的不斷發展，此中所

有信息均以我方確認為主。