SD Marine BTD         醇酸面漆
PRODUCT DESCRIPTION   An alkyd gloss finish for exterior and interior
& INTENDED USES
產品簡介              用于內部和外部的醇酸面漆
FEATURES
產品特性
                      z Quick drying
                        干燥迅速
                      z High gloss and good weathering resistance
                        良好的光澤和耐候性
                      z Good abrasion resistance
                        良好的耐磨性
                      z Good workability
                        良好的施工性能
BASIC DATA
基本數據
Color(s)                White and Other colors
顏色                    白色、各色
Mixing ratio            Ready to use
混合比率                單組分
Solids content          67%
重量固體份
Film thickness          Dry : 30-50 microns/coat Wet : 52-87 microns/coat (white)
涂裝膜厚                干膜: 30-50m/道 濕膜: 52-87m/道 (白色)
Spreading rate          Theoretical: 0.073kg/m 2/Ltr/40 microns (white)
涂覆率                  理論值 : 0.073 千克/平方米/40m (白色)
                        Practical: Various depending on surface conditions, environment, applications, etc.
                        實際值 : 與表面處理, 外界環境, 施工方法等多種因素有關。
STORAGE
儲存
Shelf temperature       -10℃-40℃
儲存溫度
Shelf life             1 year
儲存期限               1 年
Flash point            Greater than 43℃
閃點                   43℃以上

APPLICATION DATA
施工數據
Application methods
施工方法
                        Conventional spray, brush, roller
                        適用于常規噴涂、刷涂、輥涂
                        Airless spray 無空氣噴涂 Recommended 推薦
                        Nozzle tip 噴嘴尺寸 0.021-0.023
                        Fluid pressure 出口壓力 100-150kg/cm
                        Thinning 稀釋比率 0-3% by volume（體積比）
Thinner                 SD Marine Paint Thinner
稀釋劑                  專用稀釋劑
Application temperature -10℃-40℃
施工溫度
Drying time &
Overcoating interval
干燥時間&涂裝間隔
                       Temperature (℃)    溫度        -5 5 10 20 30
                       Dry to touch (hrs)  指觸干燥     4 2 1.5 1 1
                       Dry hard (hrs)      半硬干燥     24 20 12 7 5
                       Min. interval (hrs) 最小涂裝間隔 24 24 16 10 8
                       Max. interval (days) 最大涂裝間隔 -  -  -  -
PAINTING SYSTEM
涂裝配套
Preceding coat         SD Marine primer, SD Marine Build primer, or according to the
適用下涂               coating systems of Kansai.
                       SD Marine primer, SD Marine Build primer，或參考我司涂裝配套。

SURFACE PREPARATION
表面處理
                       The primer surface should be clean, dry and free of all contamination.
                       底漆表面應清潔干燥，無污物。
                       Observe the overcoating intervals specified for the primer.
                       注意施工時與底漆的涂裝間隔。
SAFETY PRECAUTIONS
安全措施                A health and safety data sheet for product is available upon request.
                        Minimum precautions to be taken in dealing with all paints are:
                        任何油漆施工中均應保證提供以下措施:
                        z Avoid skin and eye contact.
                        避免接觸皮膚和眼睛。
                        z If paint comes into contact with the skin , wash with warm water
                        and/or a suitable cleanser. If paint comes into contact with the eyes,
                        flush with copious amount of water and seek immediate medical
                        attention.
                        如果油漆接觸到皮膚，應用溫水以及（或者）適當的清洗劑清
                        洗。如果油漆接觸到眼睛，應用大量水沖洗并立即就醫。
                        z Ensure good ventilation.
                        保證良好的通風。
                        z Paint products contain flammable materials. Please keep them away
                        from sparks and prohibit any smoking in the vicinity.
                        涂料中含有可燃物質。請遠離火花并禁止在臨近地區吸煙。
                        z Observe all health and safety data on the container.
                        現場遵守一切健康安全規定。
DISCLAIMER              The information given on this sheet is to the best of our knowledge and
提請注意                accurate at the time of printing. Since conditions of use are beyond the
                        manufacture's control, information contained herein is without
                        warranty, implied or otherwise, and the suitability of the material for
                        the use contemplated is the sole responsibility of the buyer. The
                        information contained on this data sheet is subject to modification at
                        any time due to our policy of modification and product development.
                        本說明書所提供信息均為目前我方所掌握最全面正確的資料,鑒于
                        產品使用條件非我方所能控制，此中信息不含擔保，即僅在選取產
                        品上對買方負責。由于我公司產品及生產工藝的不斷發展，此中所
                        有信息均以我方確認為主。